Inline Water Filter for 1/2" Snap-on Connectors with Integrated Filtration System

Will hopefully remove bits from water, more of a very fine sieve than filter. Solid construction and adapters are ok, not cheapest or best.

Because I was looking for a prefilter for my pressure washer so that I could use rain water straight from a water but tap, I bought this filter. It's straight forward to use being fitted inline with the hose using standard hoselock fittings. The filter is easy to clean by unscrewing the ends, removing the gauze filter inside and washing it out although back flushing in most cases does the job. Remember to fit the filter with the red ring on the hoselock type fitting that screws into the tube towards the barrel and the fitting screwed on the outside of the tube with the green ring towards the outlet side. Works very well

Bought when we were refilling our hot tub and the water from the tap was full of silt and other nasties. In truth the mesh in this isn't fine enough to stop the really tiny particles but it's a good bit of kit to prolong the life of water pumps and pressure washers by stopping grit getting into the mechanism

Great little filter and connector I can draw from a Water butt and not get all the debris and rubbish going in to my hand held jet wash. Great idea and well constructed

The filter is ok but I had to buy rubber washers to seal the couplings as the ones supplied were no good

Solid construction. Easy to install and use. Filter easy to remove for cleaning by unscrewing the 1/2" male threaded quick connector from the female end. This is the same end that is connected to the tap.

Inner filter was split poorly made not recommended

As described and fast delivery