CruzixRectangle Sublimation Keychain Blanks, 80 PCS Sublimation Blanks Products Bulk with Heat Press Transfer Double-Side Printed Keychain Blanks Tassels Key Rings for DIY Office Tag Art Craft Ornament

They were okay. Very hard to remove film and some came with chips on the corner but served purpose for Christmas

I purchased these to make some keychains to match tumblers and they sublimate beautifully! Loved them so much that I immediately ordered more and will continue to order as needed! So easy to use. Getting the protective film off both side prior to sublimating at tricky but I use my cricut pick and done!

I loved these and they turned out beautifully!

great for sublimation have ordered several times and will continue to do so

These keychains sublimate great! They look very good once they are finished with the hardware included.

While i like many things about this such as it's easy to use, sublimates well, is sturdy and the price was right.... you do get what you pay for. I run an Etsy shop and tested out several of these and less than a week of use the sublimation chips off.. After all it's just a coated fiberboard. If you're looking for possibly a quick and easy sale you might have it but the reviews wont always be great if they remember to go back within 100 days and change it due to their image chipping off. I won't be using these for sale as I'd like to maintain my high 5-star review rate. I will try the coated aluminum next and cross my fingers that goes well but it is a coating again so not holding out high hopes. As for the actual package I received, some of them were already chipped so I wasn't too pleased with that as it would increase my cost due to less keychains I'd be able to sell now. However since it's an overall dud for me now, I've gotten over that.

El producto excelente!! Un poco complicado montarlos

Very small, need to be careful taking plastic off chip easily

It is a very good product, but you have to take into account the following information, a) give it a bleed of 2 mm, that is, its design must be 52 mm and not 50 mm-çb) your design should only reach 48 mm, so you do not run the risk that any information is lostb) Do not place thermal tape on the area to be sublimated, it will be marked. Therefore place the tape on the side that is not going to sublimate.c) From the bleed, place another 5 mm so that you can fold the paper and hold it to the side that is not going to sublimated) Saturate the design color in photoshop for crisp colors

Description needs measurements/size of actual disc. Not just the hole. Quality for sublimation is perfect if you follow instructions. Tassel however does not fit on keychain ring properly so it won't move around.

I’ve only used one so far, and it sublimated perfectly. Highly recommend, will buy again. Don’t forget to remove the plastic coating on both sides first. I pressed with Cricut heat press, 400 degrees for 45 seconds, no pressure, sandwiched between butcher paper.

I was excited to get these and ended up ruining a few because I didn't know that there was a protective layer. After that user error was corrected I proceeded to sublimate the keychains and much to my dismay, they all have a chip off of the side. I followed the heat and time instructions listed on amazon.

These would probably be okay except:The film that covers them is so difficult to remove and has resulted in chipping a few of the key chains because it’s almost impossible to get the film to lift.We’ve officially repackaged what’s left and put them in the closet until we find a way to peel the film. We don’t want to continue damaging them.Definitely will not bug or recommend again.